Frequency Meter. 6Digit. 100KHz-65Mhz Red


Frequency Meter. 6Digit. 100KHz-65Mhz Red
Stock Number: 35057 TE
 Review Average:  
 Number of Reviews: 2
 View ReviewsReview this item
$14.95


This item is NO LONGER available. Please use our SEARCH feature and see if you can find an alternate item for what you were looking for.
This item is no longer available


SHARE
    
     Email this to a friend     

Detailed Description

View PDF Data Sheet
DATA SHEET


PLJ-6LED is a cost-effective microprocessor based, six-digit digital frequency display/counter. It can be used for conventional frequency measurement or as a transceiver band displ;ay.
Features: small size and reliable performance.
Settings are automatically saved
Features:
Processor: Microchip PIC16F648A
Power: 8V ~ 15VDC (with reverse polarity protection )
Operating current: <90 mA
Display: 0.56in. High brightness 7 segment Red LED
8 Display Brightness settings (factory set to the highest)
Zero auto blanking,
2.5ppm Voltage Controlled TCXO Frequency reference
Unique gate control & accurate time algorithm (non-timed interrupt mode).
Gate time:
0.1 seconds
Dual IF Offset Adjustments (Independent + & - adj.)
Measurement Input:
High impedance
Range: 0.1 MHz ~ 60 MHz
Accuracy: ± 10Hz (0.1 sec. Gate)
Sensitivity: 1 MHz to 60 MHz: better than 60 mVPP
Connections:
DC IN: HX2.54-2P socket
RF IN: HX2.54-2P socket
ICSP: (factory programming interface) 2.54-6P pin
INCLUDES 6in. PIGTAIL POWER & INPUT LEADS
L: 3-5/8” W:H: 7/8” WT: .08


California Proposition 65 Warning WARNING: This product can expose you to chemicals including Nickel which is known to the State of California to cause cancer and which is known to the State of California to cause birth defects and/or other reproductive harm. For more information, go to www.P65Warnings.ca.gov



 Product ReviewsClick here to review this item
be aware if you intend to use in a radio
be aware that if your IF is above your signal frequency you cannot use this as a frequency display. The counter subtracts the IF from the signal, and if it is less than zero it displays all zeros. It works okay to display sum of signal and IF, and difference if the signal is above the IF.
GA
 
Works great
Works great and I have had no problems with the LEDs or with readings in general.